Sliding Glass Door Adjustment Screws

Inside a standard sliding glass door there are adjustable rollers that help it slide back and forth on the track.

Sliding glass door adjustment screws.

Locate the two adjusting screws at the bottom of the door on the face or edge of the door and pry off the trim caps that cover the screws. Raise it just enough to clear the track and roll smoothly. Adjusting the rollers on your pella sliding doors raises or lowers the door panel as necessary to get the door working. If the adjustment screws on your sliding glass door are broken or won t turn or if your door still isn t sliding properly even after adjustment glass doctor can help.

If that doesn t work check for damaged wheels that need to be replaced. To start your sliding glass door adjustment project first lift or lower the door on the track with a screwdriver or allen wrench. As the framing inside the door opening settles the tracks raise or lower with the floor. If the side with the adjusting screw is too high causing it to bind at the top turn the screw counterclockwise.

If it s too low use a flat pry bar to raise the door while you turn the adjusting. Locate the adjustment screws on the lower edges of the door. Never force your sliding glass door to open or close as this can cause permanent damage to the door or. There should be a uniform gap along the bottom and top edges of the door.

Most sliding glass doors contain two sets of rollers one on each side of the bottom of the door. Give the screw a clockwise turn and test to see whether the door slides easier. On my door the holes had plastic plugs in them. The sliding panel should glide across the tracks when you open the door without jamming.

How to adjust sliding glass door rollers for a smoother ride. There are holes on your sliding glass door that conceal the adjusting screws to these rollers. Call glass doctor for professional sliding glass door adjustment. Next to lower the sliding glass door use a screwdriver to turn the screws clockwise.

They may be covered by plug covers if your screws are covered by plug covers use a putty knife to remove them. Over time the framing of your home settles. To check the adjustment stand back and look at the door from the outside. Most sliding doors have a mechanism called an adjusting screw located at the bottom of the door ends.

You can alter the height of these rollers by accessing the adjustment screws which are set into slots on the door s outer edges perpendicular with the rollers themselves. Most problems are from dirty tracks or wheels. First locate the screws on the bottom of your sliding glass doors. After a bit of adjustment the.

If the door becomes even harder to open turn the screw in the opposite direction.