Tips For Vinyl Wrapping A Car

Once the vinyl is smooth it s time to remove the excess material.

Tips for vinyl wrapping a car.

1 the first step is to clean the surface with paint safe grease and wax remover to remove any dirt or grime on the surface. Don t cut any excess until you re positive there are no air bubbles. Keep in mind that the vehicle s paint is lurking under your blade. The vehicle surface temperature must be at least 60 degrees fahrenheit.

Then proceed to rinse the surface with water. Prepping for a vinyl wrap installation includes making sure your vehicle is free of dust mud wax oil protective type products and other agents that may prevent the vinyl from adhering to the vehicle surface during the installation process. Once you have a starting peel back the liner and place the vinyl wrap onto the target surface. Avoid using chrome is this is your first time applying vinyl wrap.

There is also another great thing about wrapping in sections. These vinyl cuts are designed to last for years at a time. After the vinyl sheet has adhered to the car body over the thread the thread is sharp. Use vinyl wrap on smooth substrates like glass corrugated plastic and painted aluminum.

With air release vinyl wrap you can press the air easily. Using moderate pessure on your squeegee apply the film while pushing out trapped air from beneath starting from the middle outward. Avoid using vinyl on wooden surfaces. Vinyl wrapping on your vehicle will not only last a long time but it s also going to look good doing it.

We recommend to have the car generally cleaned with car wash soap avoid using cleaners with waxes. Cut the vinyl wrap not the vehicle. Purchase roughly 15 20 feet 4 6 6 1 m more vinyl than you think you ll need in case you mess up any of the panels. This will help if you need to lift the vinyl to remove any air you can t smooth out.

Cleaning and surface prep for a successful professional car wrap. We highly recommend installers to wrap section by section which will make it easier and lower down not only the pressure for installers but also the pressure from the adhesive and the film in terms of holding the entire bumper with one giant piece.